Citation

Ma W, Wan L, Yu C, Zou L, Zheng J. Transp. Res. C Emerg. Technol. 2020; 120: e102821.

Copyright

(Copyright © 2020, Elsevier Publishing)

DOI

10.1016/j.trc.2020.102821

PMID

unavailable

Abstract

Existing fixed-time traffic signal optimization methods mainly use traffic volumes collected by infrastructure-based detectors (e.g., loop detectors). These infrastructure-based detectors generally have high maintenance costs and low coverage. With the deployment of probe vehicles, vehicle trajectory data provide more information about traffic states and can be utilized for signal timing. However, most related studies assume high penetration rates of probe vehicles or short sampling intervals. This paper develops a hierarchical multi-objective optimization framework to optimize fixed-time traffic signals based on sampled vehicle trajectories at isolated signalized intersections, which is applicable to low-resolution trajectory data. Cycle length and green splits are optimized under both under- and slightly over-saturated traffic conditions. The number of over-saturated phases and average vehicle delays are adopted as the primary and the secondary objectives, respectively. Note that the queues of over-saturated phases cannot be discharged. The queue length and traffic delay of over-saturated phases will go infinite as time goes. The consideration of the over-saturated phase number helps increase vehicle throughput and reduce queue length and traffic delay. The aggregation of sampled trajectory data during the same period across multiple cycles and Same-ratio Principles (SRPs) are proposed to compensate for the limitations of low penetration rates of probe vehicles. The evolution of sampled trajectories with varying signal timings are formulated explicitly. A sampled-trajectory-density method is proposed to identify over-saturated phases. Then a mixed integer non-linear programming (MINLP) model is formulated and transformed to a series of mixed integer linear programming (MILP) models by linearization and enumerating cycle lengths. Simulation studies validate the advantages of the proposed model over the one in Synchro Studio. Sensitivity analysis shows that: (1) the proposed model is applicable to Poisson vehicle arrivals; (2) the proposed model can handle sampling intervals as long as 15 s when sufficient sampled vehicle trajectories are collected; (3) the number of sampled trajectories has impacts on the performance of the proposed model instead of probe vehicle penetration rates, especially with under-saturated traffic; (4) cycle lengths of initial signal timing plans have no noticeable impacts on the required number of sampled trajectories when a short sampling interval is applied; and (5) the proposed model is insensitive to the quality of initial signal timing plans with under- and slightly over-saturated traffic. The proposed model is also implemented with field data to demonstrate its applicability in the real world.

Language: en

Keywords

Fixed-time signal optimization; Low penetration rate of probe vehicle; Mixed integer non-linear programming model; Trajectory data