Citation

Lim L, Buchanan AH, Moss PJ. Fire Mater. 2004; 28(2-4): 95-125.

Copyright

(Copyright © 2004, John Wiley and Sons)

DOI

unavailable

PMID

unavailable

Abstract

This paper describes the numerical analyses of restrained concrete floor slabs exposed to fire. The analyses of the slabs were carried out with the SAFIR finite element program considering a 200 mm thick slab, spanning 5 m between two end supports. The slabs were exposed to the ISO standard fire for up to 4 h and were analysed with pinned and rotationally restrained supports. Different heights of the line of thrust at the supports and different levels of axial restraint were also investigated. The analyses show that fully restrained pin-supported slabs can survive the 4h ISO fire without collapse if the position of the line of thrust is located near the soffit of the slab. If the position of the line of thrust is located much above the soffit of the slab, the slabs will rapidly undergo large deformations and sag into a catenary, imposing axial tensile forces at the supports. The analyses have shown that even if the line of thrust is located close to the soffit, the slab can still deform into a catenary if there is insufficient horizontal axial restraint. In this study, rotationally restrained slabs experience much smaller vertical deflections than pin-supported slabs when exposed to fires. Rotationally restrained slabs with low levels of horizontal restraint do not collapse, due to the beneficial effects of moment redistribution. However, high levels of horizontal restraint can be detrimental, causing slabs to collapse at advanced stages of the fire.