Citation

Marques M, Terroso M, Freitas R, Marques AT, Gabriel J, Simoes R. Accid. Anal. Prev. 2015; 75: 285-291.

Affiliation

Design Department, Polytechnic Institute of Cávado and Ave, School of Technology, Portugal; Institute for Polymers and Composites IPC/I3N, University of Minho, Portugal. Electronic address: rsimoes@ipca.pt.

Copyright

(Copyright © 2015, Elsevier Publishing)

DOI

10.1016/j.aap.2014.12.009

PMID

25541683

Abstract

Falls represent a major care and cost problem to health and social services world-widely, since 50% of falls result in an injury. In this work, is proposed a methodology to evaluate protective pads materials and geometry performance, in order to reduce impact results in a fall event. Since the material properties and the pad geometry are the key factors to make the protection possible when a fall event occurs, our approach relies on the use of mechanical tests to evaluate the properties of the material and in the study of the pad response during a fall. For this, were used compression, tensile and instrumented falling weight tests, that allow a fully characterization of the materials that can be employed in the protective pads. Likewise, to gather precise information on falls events, in order to study the pad response during a fall, a set of laboratory fall trials were created using a camera-less inertial motion capture (mocap) system. This allow the acquisition of dynamic information of falls, namely acceleration and velocity that can be used to create a finite element analysis (FEA) model, where different segments from the human body can be evaluated when the protective pad is associated to it. Through the proposed methodology, different materials and pad geometries can be studied towards maximizing the performance of protection pads for falls. The mocap system allows the acquisition of fall data, and also the creation of a human body geometrical model, representative of the fall. From the mechanical trials, was showed that the spacer fabric embedded with silicone has the higher ability to reduce the peak force in case of impact when compared with all the other specimens. The compression and the tensile tests allow the mechanical definition of the material, and with this the material definition on the FEA model.

Language: en