Citation

Russell S, Granata KP, Sheth P. J. Biomech. Eng. 2005; 127(1): 114-122.

Affiliation

Musculoskeletal Biomechanics Laboratory, Department of Engineering Science and Mechanics, School of Biomedical Engineering and Science, Virginia Polytechnic Institute and State University, Blacksburg, VA 24061, USA.

Copyright

(Copyright © 2005, American Society of Mechanical Engineers)

DOI

unavailable

PMID

15868794

PMCID

PMC1633712

Abstract

Active joint torques are the primary source of power and control in dynamic walking motion. However the amplitude, rate, timing and phasic behavior of the joint torques necessary to achieve a natural and stable performance are difficult to establish. The goal of this study was to demonstrate the feasibility and stable behavior of an actively controlled bipedal walking simulation wherein the natural system dynamics were preserved by an active, nonlinear, state-feedback controller patterned after passive downhill walking. A two degree-of-freedom, forward-dynamic simulation was implemented with active joint torques applied at the hip joints and stance leg ankle. Kinematic trajectories produced by the active walker were similar to passive dynamic walking with active joint torques influenced by prescribed walking velocity. The control resulted in stable steady-state gait patterns, i.e. eigenvalue magnitudes of the stride function were less than one. The controller coefficient analogous to the virtual slope was modified to successfully control average walking velocity. Furture developments are necessary to expand the range of walking velocities.

Language: en