Citation

Barker DW, Kini S, Bernard TE. Am. Ind. Hyg. Assoc. J. 1999; 60(1): 32-37.

Affiliation

Florida Power Corp., Crystal River, USA.

Copyright

(Copyright © 1999, American Industrial Hygiene Association)

DOI

unavailable

PMID

10028614

Abstract

The Heat Stress Index was an early model for the assessment of heat stress. The International Organization for Standardization (ISO) standard for required sweat rate is the current generation of heat balance methods for occupational heat stress. The method assumes cotton clothing and works adequately for cotton/polyester blends. To extend the usefulness of the model, the thermal characteristics of a variety of commercially available and prototype protective clothing ensembles have been determined for application in the ISO method. The fundamental principle for assessing thermal characteristics of work clothing is establishing the critical environmental conditions in which test subjects were just able to maintain thermal equilibrium. Critical conditions were found for warm, humid conditions; hot, dry conditions; intermediate conditions of temperature and humidity; and/or moderate conditions in which metabolic rate was increased to a limiting thermal load. Typically, five subjects at each condition for each ensemble were used. Metabolic rate, average skin temperature, and the environmental conditions (air temperature and vapor pressure) were noted at the critical conditions, and the total insulation was estimated for each ensemble. From these values, the total evaporative resistance, the clothing factor for dry heat exchange (CFcl), and the clothing factor for evaporative cooling (CFpcl) were determined. When compared with reports of others on thermal characteristics the results agreed when pumping factors and clothing wetness were considered. The result was higher than expected values for CFcl and lower values for CFpcl.

Language: en