Citation

Lewis WG, Narayan CV. Appl. Ergon. 1993; 24(5): 351-356.

Affiliation

Department of Mechanical Engineering, Faculty of Engineering, The University of the West Indies, USA.

Copyright

(Copyright © 1993, Elsevier Publishing)

DOI

unavailable

PMID

15676932

Abstract

In this paper, handles for two commonly used hand tools, the chisel and the off-set pliers, are designed using ergonomic principles. These were sized for both males and females falling in the 5th percentile, 50th percentile and 95th percentile groupings. The stresses developed in the ergonomically designed chisel handle while in use were analysed to verify the validity of the design. This chisel handle was then manufactured, and preliminary evaluation using electromyography was conducted. In these tests, the stresses exerted on the flexor and extensor muscles of the arm were measured and compared with those obtained during the use of a conventional handle. Under similar working conditions, results clearly showed that the ergonomically designed handle allows higher working efficiency than existing handles.

Language: en