Citation

Huang S, Yang J. Accid. Anal. Prev. 2010; 42(4): 1136-1143.

Affiliation

Department of Applied Mechanics, Chalmers University of Technology, Horsalsvagen, Göteborg, Sweden. sunan.huang@chalmers.se

Copyright

(Copyright © 2010, Elsevier Publishing)

DOI

10.1016/j.aap.2009.12.028

PMID

20441823

Abstract

This study evaluated and optimized the performance of a reversible hood (RH) for the prevention of the head injuries of an adult pedestrian from car collisions. The FE model of a production car front was introduced and validated. The baseline RH was developed from the original hood in the validated car front model. In order to evaluate the protective performance of the baseline RH, the FE models of an adult headform and a 50th percentile human head were used in parallel to impact the baseline RH. Based on the evaluation, the response surface method was applied to optimize the RH in terms of the material stiffness, lifting speed, and lifted height. Finally, the headform model and the human head model were again used to evaluate the protective performance of the optimized RH. It was found that the lifted baseline RH can obviously reduce the impact responses of the headform model and the human head model by comparing with the retracted and lifting baseline RH. When the optimized RH was lifted, the HIC values of the headform model and the human head model were further reduced to much lower than 1000. The risk of pedestrian head injuries can be prevented as required by EEVC WG17.

Language: en